ClassicOldsmobile.com - View Single Post

bmwashington · 04-25-2007, 06:34 AM

I have a 67 Delmont convertible. There is a hole about the size of my hand in the rear driver side pan between where the seat belts fasten

. So, I'm looking not for the whole floor pan, but just a piece to weld in. If need be, I could fabricate/weld some sheet metal. The rest of the floor is fine.

04-25-2007, 06:34 AM	#7 (permalink)
bmwashington Junior Member Join Date: Mar 2007 Posts: 8	I have a 67 Delmont convertible. There is a hole about the size of my hand in the rear driver side pan between where the seat belts fasten . So, I'm looking not for the whole floor pan, but just a piece to weld in. If need be, I could fabricate/weld some sheet metal. The rest of the floor is fine.